This is an old revision of the document!

Directions for Using the Dubbing Station

Dubbing Station Guide - DVD

The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (help.desk@olin.edu or x2430).

Station Support:

The dubbing station currently supports DVD to DVD dubbing and VHS to VHS dubbing. Please contact the Help Desk for assistance with other setups.

Directions for Dubbing (DVD):

DVD Players being used:

  • SOURCE → Samsung DVD-P231 (REMOTE LABELED AS DVD S)
  • DESTINATION → LITEON LVW 5005 (REMOTE LABELED AS DVD D)

:!: Make sure the RCA cables labeled DVD are connected to the TV Set (see image below)

:!: Use Y 2 to 1 connector.

  1. Turn on TV and tune it to Line Input.
  2. Turn on the Source and Destination DVD players. Insert the material you wish to be recorded into the Source DVD player, and your blank media into the Destination DVD player.
  3. Using the Destination DVD Remote (DVD D), use the Source button (located at the bottom-left) to select AV2-Rear. This will allow you to see the source DVD.
  4. Using the Source DVD Remote (DVD S), find the point on the DVD from which you wish to begin copying.
  5. Once you are ready to record, press record on the Destination DVD player, then press play on the Source DVD player.
  6. When finished recording, press stop on both players
  7. Repeat editing process until you are finished. (To copy multiple clips, repeat 4-6 until finished)
  8. You can remove DVD tracks if you are not satisfied (using DVD-R/-RW, DVD+R/+RW media only). See attachments for these edits.
  9. You must finalize your DVD in order for it to be viewable on other DVD players. Follow the directions attached at the end of the document (NOTE: Follow directions for Model 5005).