Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
dubbing_station_guide_-_vcr [2012/06/05 14:21]
dterry
dubbing_station_guide_-_vcr [2013/08/22 09:15]
jbeck
Line 3: Line 3:
 ===Dubbing Station Guide - VCR=== ===Dubbing Station Guide - VCR===
  
-The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (help.desk@olin.edu or x. 2430).+The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (helpdesk@olin.edu or x. 2430).
  
 **The Players:** **The Players:**
Line 18: Line 18:
 **Directions for Dubbing:** **Directions for Dubbing:**
  
-:!: Make sure the RCA cables labeled VCR are connected to the TV Set (see image below)+  * Make sure the RCA cables labeled VCR are connected to the TV Set (see image below)
  
 :!: Use **Y** 2 to 1 connector. :!: Use **Y** 2 to 1 connector.
  
-{{:it:av_jacks.jpg|}}+{{av_jacks.jpg|}}
  
  
-- Turn on TV and tune it to Line Input. +  ​-Turn on TV and tune it to Line Input. 
-- Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. +  -Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. 
-- Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. +  -Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. 
-- Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. +  -Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. 
-- Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. +  -Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. 
-- When finished recording, press stop on both players.  +  -When finished recording, press stop on both players.  
-- Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished)+  -Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished)