Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
dubbing_station_guide_-_vcr [2012/06/05 14:19]
dterry
dubbing_station_guide_-_vcr [2013/08/22 09:15] (current)
jbeck
Line 3: Line 3:
 ===Dubbing Station Guide - VCR=== ===Dubbing Station Guide - VCR===
  
-The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (help.desk@olin.edu or x. 2430).+The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (helpdesk@olin.edu or x. 2430).
  
 **The Players:** **The Players:**
Line 17: Line 17:
  
 **Directions for Dubbing:** **Directions for Dubbing:**
-  - Make sure the RCA cables labeled VCR are connected to the TV Set (see image below)+ 
 +  * Make sure the RCA cables labeled VCR are connected to the TV Set (see image below) 
 :!: Use **Y** 2 to 1 connector. :!: Use **Y** 2 to 1 connector.
  
-{{:it:av_jacks.jpg|}}+{{av_jacks.jpg|}} 
  
 +  -Turn on TV and tune it to Line Input.
 +  -Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player.
 +  -Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input.
 +  -Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying.
 +  -Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player.
 +  -When finished recording, press stop on both players. ​
 +  -Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished)
  
-  2.  Turn on TV and tune it to Line Input. 
-  3.  Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. 
-  4.  Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. 
-  5.  Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. 
-  6.  Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. 
-  7.  When finished recording, press stop on both players. ​ 
-  8.  Repeat the editing process until you are finished. (To copy multiple clips, repeat 6-8 until finished)