Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
dubbing_station_guide_-_dvd [2012/06/05 14:10]
dterry
dubbing_station_guide_-_dvd [2013/08/22 09:14] (current)
jbeck
Line 2: Line 2:
  
 ===Dubbing Station Guide - DVD=== ===Dubbing Station Guide - DVD===
-The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (help.desk@olin.edu or x2430).+The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (helpdesk@olin.edu or x2430).
  
 **Station Support:** **Station Support:**
Line 18: Line 18:
  
  
-{{:it:av_jacks.jpg|}}+{{av_jacks.jpg|}}
  
 :!: Use **Y** 2 to 1 connector. :!: Use **Y** 2 to 1 connector.
Line 24: Line 24:
   - Turn on TV and tune it to Line Input.   - Turn on TV and tune it to Line Input.
   - Turn on the Source and Destination DVD players. Insert the material you wish to be recorded into the Source DVD player, and your blank media into the Destination DVD player.   - Turn on the Source and Destination DVD players. Insert the material you wish to be recorded into the Source DVD player, and your blank media into the Destination DVD player.
-  - Using the Destination DVD Remote (DVD D, use the Source button (located at the bottom-left) to select **AV2-Rear.** This will allow you to see the source DVD.+  - Using the Destination DVD Remote (DVD D), use the Source button (located at the bottom-left) to select **AV2-Rear.** This will allow you to see the source DVD.
   - Using the Source DVD Remote (DVD S), find the point on the DVD from which you wish to begin copying.   - Using the Source DVD Remote (DVD S), find the point on the DVD from which you wish to begin copying.
   - Once you are ready to record, press record on the Destination DVD player, then press play on the Source DVD player.   - Once you are ready to record, press record on the Destination DVD player, then press play on the Source DVD player.
Line 30: Line 30:
   - Repeat editing process until you are finished. (To copy multiple clips, repeat 4-6 until finished)   - Repeat editing process until you are finished. (To copy multiple clips, repeat 4-6 until finished)
   - You can remove DVD tracks if you are not satisfied (using DVD-R/-RW, DVD+R/+RW media only). See attachments for these edits.   - You can remove DVD tracks if you are not satisfied (using DVD-R/-RW, DVD+R/+RW media only). See attachments for these edits.
-  - You must finalize your DVD in order for it to be viewable on other DVD players. Follow the directions attached at the end of the document (NOTE: ​Follow ​directions for Model 5005).+  - You must finalize your DVD in order for it to be viewable on other DVD players. Follow the directions attached at the end of the document (NOTE: ​__Follow ​directions for Model 5005__).