Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision 		Previous revision
Next revision Both sides next revision
dubbing_station_guide_-_vcr [2011/07/19 10:05]
127.0.0.1 external edit 		dubbing_station_guide_-_vcr [2012/06/05 14:33]
dterry
Line 13: Line 13:
   * SOURCE -> JVC SR-V530 (NOTE: REMOTE LABELED AS **VCRS**)   * SOURCE -> JVC SR-V530 (NOTE: REMOTE LABELED AS **VCRS**)
   * DESINATION -> Panasonic – AG-2580P (NOTE: REMOTE LABELED AS **VCRD**)   * DESINATION -> Panasonic – AG-2580P (NOTE: REMOTE LABELED AS **VCRD**)
-  * +
 :!: It is recommended that you do not use the remotes. They are available but both VCR's receive signals at the same frequency. :!: It is recommended that you do not use the remotes. They are available but both VCR's receive signals at the same frequency.
  
 **Directions for Dubbing:** **Directions for Dubbing:**
-  - Make sure the RCA cables labeled VCR are connected to the TV Set (see image below)+ 
 +* Make sure the RCA cables labeled VCR are connected to the TV Set (see image below) 
 :!: Use **Y** 2 to 1 connector. :!: Use **Y** 2 to 1 connector.
  
Line 23: Line 25:
  
  
-  - Turn on TV and tune it to Line Input. +  -Turn on TV and tune it to Line Input. 
-  - Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. +  -Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. 
-  - Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. +  -Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. 
-  - Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. +  -Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. 
-  - Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. +  -Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. 
-  - When finished recording, press stop on both players. +  -When finished recording, press stop on both players.  
-  - Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished)+  -Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished)