Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
dubbing_station_guide_-_vcr [2012/06/05 14:19] dterry |
dubbing_station_guide_-_vcr [2022/12/04 23:34] rosterberg removed |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ===Dubbing Station Guide - VCR=== | ===Dubbing Station Guide - VCR=== | ||
| - | The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (help.desk@olin.edu or x. 2430). | + | The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (helpdesk@olin.edu or x. 2430). |
| **The Players:** | **The Players:** | ||
| Line 17: | Line 17: | ||
| **Directions for Dubbing:** | **Directions for Dubbing:** | ||
| - | - Make sure the RCA cables labeled VCR are connected to the TV Set (see image below) | + | |
| + | * Make sure the RCA cables labeled VCR are connected to the TV Set (see image below) | ||
| :!: Use **Y** 2 to 1 connector. | :!: Use **Y** 2 to 1 connector. | ||
| - | {{:it:av_jacks.jpg|}} | + | {{av_jacks.jpg|}} |
| + | -Turn on TV and tune it to Line Input. | ||
| + | -Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. | ||
| + | -Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. | ||
| + | -Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. | ||
| + | -Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. | ||
| + | -When finished recording, press stop on both players. | ||
| + | -Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished) | ||
| - | 2. Turn on TV and tune it to Line Input. | ||
| - | 3. Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. | ||
| - | 4. Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. | ||
| - | 5. Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. | ||
| - | 6. Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. | ||
| - | 7. When finished recording, press stop on both players. | ||
| - | 8. Repeat the editing process until you are finished. (To copy multiple clips, repeat 6-8 until finished) | ||