Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
dubbing_station_guide_-_vcr [2012/06/05 14:21]
dterry 		dubbing_station_guide_-_vcr [2022/12/04 23:34]
rosterberg removed
Line 3: Line 3:
 ===Dubbing Station Guide - VCR=== ===Dubbing Station Guide - VCR===
  
-The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (help.desk@olin.edu or x. 2430).+The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (helpdesk@olin.edu or x. 2430).
  
 **The Players:** **The Players:**
Line 18: Line 18:
 **Directions for Dubbing:** **Directions for Dubbing:**
  
-:!: Make sure the RCA cables labeled VCR are connected to the TV Set (see image below)+  * Make sure the RCA cables labeled VCR are connected to the TV Set (see image below)
  
 :!: Use **Y** 2 to 1 connector. :!: Use **Y** 2 to 1 connector.
  
-{{:it:av_jacks.jpg|}}+{{av_jacks.jpg|}}
  
  
-- Turn on TV and tune it to Line Input. +  ​-Turn on TV and tune it to Line Input. 
-- Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. +  -Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. 
-- Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. +  -Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. 
-- Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. +  -Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. 
-- Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. +  -Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. 
-- When finished recording, press stop on both players.  +  -When finished recording, press stop on both players.  
-- Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished)+  -Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished)