Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
dubbing_station_guide_-_vcr [2013/08/22 09:15]
jbeck 		— (current)
Line 1: Line 1:
-=====Directions for Using the Dubbing Station===== 
- 
-===Dubbing Station Guide - VCR=== 
- 
-The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (helpdesk@olin.edu or x. 2430). 
- 
-**The Players:** 
- 
-The dubbing station currently supports VHS/DV to VHS dubbing and DVD to DVD dubbing. Please contact the Help Desk for assistance with other setups. 
- 
-**Directions for Dubbing (VCR):** 
-__VCR Players being used:__ 
-  * SOURCE -> JVC SR-V530 (NOTE: REMOTE LABELED AS **VCRS**) 
-  * DESINATION -> Panasonic – AG-2580P (NOTE: REMOTE LABELED AS **VCRD**) 
- 
-:!: It is recommended that you do not use the remotes. They are available but both VCR's receive signals at the same frequency. 
- 
-**Directions for Dubbing:** 
- 
-  * Make sure the RCA cables labeled VCR are connected to the TV Set (see image below) 
- 
-:!: Use **Y** 2 to 1 connector. 
- 
-{{av_jacks.jpg|}} 
- 
- 
-  -Turn on TV and tune it to Line Input. 
-  -Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. 
-  -Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. 
-  -Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. 
-  -Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. 
-  -When finished recording, press stop on both players. ​ 
-  -Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished)