Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
dubbing_station_guide_-_vcr [2012/06/05 14:21] dterry |
dubbing_station_guide_-_vcr [2013/08/22 09:15] jbeck |
||
---|---|---|---|
Line 3: | Line 3: | ||
===Dubbing Station Guide - VCR=== | ===Dubbing Station Guide - VCR=== | ||
- | The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (help.desk@olin.edu or x. 2430). | + | The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (helpdesk@olin.edu or x. 2430). |
**The Players:** | **The Players:** | ||
Line 18: | Line 18: | ||
**Directions for Dubbing:** | **Directions for Dubbing:** | ||
- | :!: Make sure the RCA cables labeled VCR are connected to the TV Set (see image below) | + | * Make sure the RCA cables labeled VCR are connected to the TV Set (see image below) |
- | :!: Use **Y** 2 to 1 connector. | + | :!: Use **Y** 2 to 1 connector. |
- | {{:it:av_jacks.jpg|}} | + | {{av_jacks.jpg|}} |
- | - Turn on TV and tune it to Line Input. | + | -Turn on TV and tune it to Line Input. |
- | - Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. | + | -Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. |
- | - Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. | + | -Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. |
- | - Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. | + | -Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. |
- | - Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. | + | -Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. |
- | - When finished recording, press stop on both players. | + | -When finished recording, press stop on both players. |
- | - Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished) | + | -Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished) |