Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
dubbing_station_guide_-_vcr [2012/06/05 14:21] dterry |
— (current) | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | =====Directions for Using the Dubbing Station===== | ||
- | ===Dubbing Station Guide - VCR=== | ||
- | |||
- | The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (help.desk@olin.edu or x. 2430). | ||
- | |||
- | **The Players:** | ||
- | |||
- | The dubbing station currently supports VHS/DV to VHS dubbing and DVD to DVD dubbing. Please contact the Help Desk for assistance with other setups. | ||
- | |||
- | **Directions for Dubbing (VCR):** | ||
- | __VCR Players being used:__ | ||
- | * SOURCE -> JVC SR-V530 (NOTE: REMOTE LABELED AS **VCRS**) | ||
- | * DESINATION -> Panasonic – AG-2580P (NOTE: REMOTE LABELED AS **VCRD**) | ||
- | |||
- | :!: It is recommended that you do not use the remotes. They are available but both VCR's receive signals at the same frequency. | ||
- | |||
- | **Directions for Dubbing:** | ||
- | |||
- | :!: Make sure the RCA cables labeled VCR are connected to the TV Set (see image below) | ||
- | |||
- | :!: Use **Y** 2 to 1 connector. | ||
- | |||
- | {{:it:av_jacks.jpg|}} | ||
- | |||
- | |||
- | - Turn on TV and tune it to Line Input. | ||
- | - Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. | ||
- | - Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. | ||
- | - Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. | ||
- | - Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. | ||
- | - When finished recording, press stop on both players. | ||
- | - Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished) |