Olin Information Technology

The following document will go over use the dubbing station that can be used for editing DVD media. For further assistance, contact the Help Desk (help.desk@olin.edu or x. 2430).

The Players:

The dubbing station currently supports VHS/DV to VHS dubbing and DVD to DVD dubbing. Please contact the Help Desk for assistance with other setups.

Directions for Dubbing (VCR): VCR Players being used:

• SOURCE → JVC SR-V530 (NOTE: REMOTE LABELED AS VCRS)
• DESINATION → Panasonic – AG-2580P (NOTE: REMOTE LABELED AS VCRD)

It is recommended that you do not use the remotes. They are available but both VCR's receive signals at the same frequency.

Directions for Dubbing:

Make sure the RCA cables labeled VCR are connected to the TV Set (see image below)

Use Y 2 to 1 connector.

-Turn on TV and tune it to Line Input. -Turn on Source and Destination VCR players. Place the VHS or DV tape to be copied into the Source player, and your blank VHS into the Destination player. -Using the Destination VCR, press the Channel buttons (located under the VHS bay) until you reach the L-1 input. -Using the Source VCR player, find the point on the VHS or DV tape from which you wish to begin copying. -Once you are ready to record, press record on the Destination VCR player, then press play on the Source VCR player. -When finished recording, press stop on both players. -Repeat the editing process until you are finished. (To copy multiple clips, repeat 5-7 until finished)