Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
jenzabar_installation [2020/09/23 09:14] mamaral [Installation and Logon Procedures for Jenzabar] |
jenzabar_installation [2020/09/23 09:22] mamaral [Installation and Logon Procedures for Jenzabar] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Installation and Logon Procedures for Jenzabar ====== | ====== Installation and Logon Procedures for Jenzabar ====== | ||
+ | ==== Installing SSH client ==== | ||
- Go to Run.. (Windows Key + R) and paste the following into the Run box and press **OK**: | - Go to Run.. (Windows Key + R) and paste the following into the Run box and press **OK**: | ||
* [[\\fsvs01\Applications\Public\SSH\Workstation\Windows\v3.2.9\SSHSecureShellClient-3.2.9.exe]] | * [[\\fsvs01\Applications\Public\SSH\Workstation\Windows\v3.2.9\SSHSecureShellClient-3.2.9.exe]] | ||
* Use all the default settings until the installation completes itself (aka: Yes it to death☺) | * Use all the default settings until the installation completes itself (aka: Yes it to death☺) | ||
- | - Install QuickMate v1.4 | + | ==== Installing QuickMate v1.4==== |
+ | * Installation instructions: | ||
+ | * [[\\FSVS01\Applications\Public\Quickmate\Install-Jenzabar-QuickMate-1_4.docx]] | ||
* Go to Run.. (Windows Key + R) and paste the following into the Run box and press **OK**: | * Go to Run.. (Windows Key + R) and paste the following into the Run box and press **OK**: | ||
* [[\\fsvs01\Applications\Public\Quickmate\v1.4\qm1_4.exe]] | * [[\\fsvs01\Applications\Public\Quickmate\v1.4\qm1_4.exe]] | ||
- | - At the Welcome screen, press **Next** | + | |
- | - At the Setup Type screen, choose **Stand-alone Workstation** and then press **Next** - | + | |
- | - At the Choose Destination Location screen, press **Next** | + | |
- | - At the Select Program Folder, choose **Next** | + | |
- | - At the Preserving Local Settings screen, select **Use new global settings**, and press **Next** | + | |
- | - At the Start Copying Files screen, press **Next** | + | |
- | - At the Setup Complete screen, leave the settings as is and press **Finish Configuration** | + | |
- | - When the Configuration Wizard opens, check the box that says **'Do not always start the Configuration Wizard’** | + | |
- | - Press **Next** | + | |
- | - At the Configure Authorized Hosts screen, press the button for **Configure...Hosts allowed to connect to QuickMate** | + | |
- | - Add the following address: | + | |
- | * ''cx01.olin.edu '' | + | |
- | - After they have been added, press **OK** | + | |
- | - Once this is done, simply press **Next** for the rest of the configuration screens | + | |
- | - Quickmate will now be installed | + | |
===== Jenzabar Log In ===== | ===== Jenzabar Log In ===== |