Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
jenzabar_installation [2020/09/23 09:14] mamaral [Installation and Logon Procedures for Jenzabar] |
jenzabar_installation [2020/10/02 14:50] mamaral [Installing QuickMate v1.4] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Installation and Logon Procedures for Jenzabar ====== | ====== Installation and Logon Procedures for Jenzabar ====== | ||
| + | ==== Installing SSH client ==== | ||
| - Go to Run.. (Windows Key + R) and paste the following into the Run box and press **OK**: | - Go to Run.. (Windows Key + R) and paste the following into the Run box and press **OK**: | ||
| * [[\\fsvs01\Applications\Public\SSH\Workstation\Windows\v3.2.9\SSHSecureShellClient-3.2.9.exe]] | * [[\\fsvs01\Applications\Public\SSH\Workstation\Windows\v3.2.9\SSHSecureShellClient-3.2.9.exe]] | ||
| * Use all the default settings until the installation completes itself (aka: Yes it to death☺) | * Use all the default settings until the installation completes itself (aka: Yes it to death☺) | ||
| - | - Install QuickMate v1.4 | + | ==== Installing QuickMate v1.4==== |
| + | * Installation instructions: | ||
| + | * [[\\FSVS01\Applications\Public\Quickmate\Install-Jenzabar-QuickMate-1_4.docx]] | ||
| * Go to Run.. (Windows Key + R) and paste the following into the Run box and press **OK**: | * Go to Run.. (Windows Key + R) and paste the following into the Run box and press **OK**: | ||
| - | * [[\\fsvs01\Applications\Public\Quickmate\v1.4\qm1_4.exe]] | + | * [[\\fsvs01\Applications\Public\Quickmate\v1.4\setup.exe]] |
| - | - At the Welcome screen, press **Next** | + | |
| - | - At the Setup Type screen, choose **Stand-alone Workstation** and then press **Next** - | + | |
| - | - At the Choose Destination Location screen, press **Next** | + | |
| - | - At the Select Program Folder, choose **Next** | + | |
| - | - At the Preserving Local Settings screen, select **Use new global settings**, and press **Next** | + | |
| - | - At the Start Copying Files screen, press **Next** | + | |
| - | - At the Setup Complete screen, leave the settings as is and press **Finish Configuration** | + | |
| - | - When the Configuration Wizard opens, check the box that says **'Do not always start the Configuration Wizard’** | + | |
| - | - Press **Next** | + | |
| - | - At the Configure Authorized Hosts screen, press the button for **Configure...Hosts allowed to connect to QuickMate** | + | |
| - | - Add the following address: | + | |
| - | * ''cx01.olin.edu '' | + | |
| - | - After they have been added, press **OK** | + | |
| - | - Once this is done, simply press **Next** for the rest of the configuration screens | + | |
| - | - Quickmate will now be installed | + | |
| ===== Jenzabar Log In ===== | ===== Jenzabar Log In ===== | ||